|
|
|
|
3D Touch sensor for automatic levelling, 1m
|
Technical data and information
Voltage: 5V
Current: 15mA
Maximum current (peak): 300mA
Housing Material: PC
Housing color: white translucent
Cable length:
- Short: 200mm
- Long: 1000mm
Cable:
3 pin: Green: -GND / Red: +5V / Orange: Signal cable
2 pin: Black: -GND / White: Z min
Product descriptions Instructions
- Once you receive the module, do not install it to the printer. First connect the module's signal wires to the motherboard one by one. After turning on the power, there will be the action of sucking the needle and pressing the needle, which is normal.
- When the motherboard and module are powered on, do not turn the wires on and off accidentally. Please make sure to connect when the power is off.
- After the firmware setup is completed, it is still uncertain whether the setup is correct. You can manually trigger the module beforehand to check if the machine is working normally.
- If it is abnormal, please stop it in time and check the firmware settings again. Do not allow the probe to hit the platform, causing damage to the module.
- Because there are too many manufacturers and models of motherboards, we advise customers to consult the motherboard manufacturer for the specific settings. To prevent incorrect settings due to different motherboards.
|
